If your router or satellite's Orbi white light is blinking, there's probably a setup or connectivity problem. Even though the white blinking light might be annoying, there are typically simple troubleshooting techniques to fix it.
Orbi white light blinking usually indicates that the router is attempting to sync with a satellite, updating its firmware, or powering up. An issue that requires attention is indicated if the light continues to flash for longer than usual (usually more than a few minutes).
The blinking white light Orbi problem can be resolved as follows:
- Turn Off and On Your Orbi Equipment
Unplug your satellites and Orbi router from the power source. After a half-hour, plug them back in. Allow them to fully start up for a few minutes. This frequently fixes little software bugs that are generating the flickering light.
- Look for updates to the firmware
The Orbi system occasionally becomes unresponsive when updating. In your browser, type http://orbilogin.com to access the Orbi Router Setup page. To see if your devices require upgrades, select Advanced Administration Firmware Update. If so, manually update and restart.
- Orbi Satellite Resync
Press the Sync button on the back of the router and the satellite if the white light is blinking on a satellite. A decent connection is indicated by amber; a solid blue connection is indicated by solid blue.
- As a last option, factory reset
Try doing a factory reset if all else fails. Holding down the reset button on the rear will cause the LED to glow amber for around ten seconds. Reconfigure your network using the Orbi mobile app or the Orbi Router Setup webpage.
Last Tip: Verify that your modem is sending a strong internet signal to your Orbi router. Sometimes, your modem settings or ISP is the problem rather than Orbi.
It's irritating to deal with a blinking white light Orbi issue, but following these instructions should quickly get your mesh system back up and running.
Grab more details by visiting our website.
